This is an old revision of the document!
PREPARATION FOR TUNING In S3 vault
Arm dump switches Make sure object ion gauge is off
Go to page xx on Panel Mate xxx. Check status xxx Ensure viewer is ready
Make sure gas bottles for FP detectors are open Make sure Intermediate PPACs have gas
In data-U
Start Software tools PanelMates NMR GUIs Barney Labview Gas Handling System Controls Labview Bias Controls Alarm servers and monitors Linux HV controls (alarm server should be started first) SpecTcl (alart server should be started first) Run Control (in coordination with experimenters) Trigger Control GUI (in coordination with experimenters) Scalers (in coordination with experimenters) Put 10 Amps in Spectrograph dipoles
Start gas in detectors
Refer to Section xx (S800 Focal Plane Gas Handling System Operation)
Enable crad04 with a rate limit of 20 kHz (crad04 looks at E1 up) If it does not interfere with experimenter preparation (see “Unreacted Beam” section below) Set spectrograph Brho Start scalers