Differences

This shows you the differences between two versions of the page.

--- cobo_testing [2014/12/08 13:04] – abunimeh
+++ cobo_testing [2014/12/08 13:41] (current) – [Power] abunimeh
@@ Line 1: / Line 1: @@
 ====== Hardware Requirements ======
-* µTCA crate equipped with MCH, JTAG modules, 1KW power supply
+  * µTCA crate equipped with MCH, JTAG modules, 1KW power supply
-* CoBo v1.0 AMC
+  * CoBo v1.0 AMC
-* 4 x AsAd boards, 4 x VHDCI cables and 4 x power cables
+  * 4 x AsAd boards, 4 x VHDCI cables and 4 x power cables
-* Power supply 3.6V 6A minimum for Asads
+  * Power supply 3.6V 6A minimum for Asads
-* PC running Fedora, connected via Ethernet to MCH
+  * PC running Fedora, connected via Ethernet to MCH
-* Xilinx JTAG programmer USB brick
+  * Xilinx JTAG programmer USB brick
-* Micro-USB cable
+  * Micro-USB cable
 ====== Software Requirements ======
-* NXP LPC chip should be flashed with VadaTech software
+  * NXP LPC chip should be flashed with VadaTech software
-* FRU and SDR should have correct values
+  * FRU and SDR should have correct values
-* Xilinx v14.7 tools should be installed on PC (xmd)
+  * Xilinx v14.7 tools should be installed on PC (xmd)
-* GetController software suite should be installed on PC
+  * GetController software suite should be installed on PC
-* PC needs to run some version of DHCP server (dnsmasq), as well as NFS server.
+  * PC needs to run some version of DHCP server (dnsmasq), as well as NFS server.
 ====== Power ======
+Click on Image below to see voltage test points.
+{{:cobov1.0_voltages_ann.png?direct&100|}}
 ====== LEDs ======
 ====== UART ======