Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
fillsystem:alarmresponse [2013/05/07 11:59] weisshaa |
fillsystem:alarmresponse [2013/05/07 12:01] weisshaa |
||
|---|---|---|---|
| Line 31: | Line 31: | ||
| __Detector warm II__ | __Detector warm II__ | ||
| * What happened: Detector runs out of LN and really warms up | * What happened: Detector runs out of LN and really warms up | ||
| - | * IMPORTANT: detector T increased by few Kelvin only, see example plot. | + | * IMPORTANT: detector T increased by few Kelvin only, see example plot below. |
| * Run run-gln-ui.sh | * Run run-gln-ui.sh | ||
| * Say 'fill det#', confirm that you want to fill it. | * Say 'fill det#', confirm that you want to fill it. | ||
| * Say 'coff det#', this stops T checking (and alarming and disabling) of this detector | * Say 'coff det#', this stops T checking (and alarming and disabling) of this detector | ||
| * Watch the fill, check for reasonable fill time (not that LN out is triggering much too early) | * Watch the fill, check for reasonable fill time (not that LN out is triggering much too early) | ||
| - | * After fill, within ~30 min the temperature should recover (see example plot). | + | * After fill, within ~30 min the temperature should recover (see example plot below). |
| * If T is good say 'con #det', so T checking is enabled again. | * If T is good say 'con #det', so T checking is enabled again. | ||
| * If it is deep in the night: You can temporary increase T high threshold (F3 directive) | * If it is deep in the night: You can temporary increase T high threshold (F3 directive) | ||
| Line 42: | Line 42: | ||
| + | |||
| + | Here an real-life example. After alarm got received | ||
| {{:fillsystem:warm-up-example.pdf|}} | {{:fillsystem:warm-up-example.pdf|}} | ||
