This is an old revision of the document!

validate: Channels which triggered get written

TTCS: All 40 channels of a triggering crystal get written

in Run directory, file Setpoints: CryG_CS_BRE is status of baseline restorer

Run lists:

date directory run Description
6/1/12 data1b/MSUMay2012 37 60Co validate
38 60Co TTCS
46 152Eu+60Co, 4kHz/xtal, mode 3
50 56Co, Mode 2+3, 1.5Mb/s, dt 92%
55 56Co, mode 2,3
56 56Co, mode 2
57 56Co, mode 2+3
58 56Co, mode 3, TTCS
59 56Co, mode 3, validate, trace 2us
60 56Co, mode 3, validate, trace 0.2us
61 60Co 10uCi, mode 3, validate, trace 0.2us
62 60Co, mode 3, validate, trace 2us
63 60Co, mode 3, TTCS
64 60Co, mode 2+3
65 60Co, mode 2
66 152Eu, mode 2
67 152Eu, mode 2+3
68 152Eu, mode 3, TTCS
69 152Eu, mode 3, validate, 2us
70 152Eu, mode 3, validate, 0.2us
71 226Ra, mode 3, validate, 0.2us
72 226Ra, mode 3, validate, 2us traces
73 226Ra, mode 3, TTCS
74 226Ra, mode 3
75 226Ra, mode 2
6/4/12 data1b/MSUMay2012 84 calibration works, low rate 60Co, mode 2+3
85 low rate 60Co, 2+3
87 226Ra, mode 3 validate, 2us traces
89 226Ra, mode 3 validate, 2us traces
92 226Ra, mode 3 validate, 2us traces
94 226Ra, mode 3 validate, 2us traces
101 switched to Gretina+S800, TTCS, mode 2+3
102 60Co mode 2+3
105 60Co, downscaler 10, crystal 5000Mb/sec
107 60Co, d/s 5
110 60Co, d/s 3
data1a/MSUJune2012 7 60Co, d/s 1, 8000Mb/sec, 18% DT
6/5/12 data1a/MSUJune2012 10 5Mev range in mode 2+3, 60Co weak, d/s 10
12 5MeV range in mode 2+3, 152Eu at center, d/s 10, BLR off
13 5MeV, mode 2+3, 152Eu center, d/s 5, BLR off
14 mode 3 validate, 0.2us trace, 152Eu center, d/s 10, BLR off
15 mode 3 validate, 0.2us trace, 152Eu center, d/s 10, BLR off, HEMIs closed!
16 mode 2+3, 152Eu center, d/s 10, BLR off, HEMIs closed!
17 mode 2+3, 60Co (weak) center, d/s 10, BLR off, HEMIs closed!
23 mode 3 validate, 0.2us, 60Co (weak) center, d/s 10, BLR off, HEMIs closed!
24 mode 3 validate, 0.2us, 60Co (weak) center, d/s 10, BLR off, HEMIs open!
25 mode 2+3, 60Co (weak) center, d/s 10, BLR off, HEMIs open!
27 mode 2+3, no source, d/s 1, BLR off, HEMIs closed!
6/6/12 data1a/MSUJune2012 28 mode 2+3, no source, d/s 1, BLR off, HEMIs open!
FROM HERE ON S800 SYNCHRONIZATION SET UP WRONG (most likely)
59 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20, most likely S800 did run with internal clock since then → no 'obvious' correlation
60 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
61 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
62 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
63 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
65 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
6/7/12 data1a/MSUJune2012 67 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
69 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20, fill during Run
70 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
71 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
72 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
6/8/12 data1a/MSUJune2012 73 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
108 mode 2only Decomp 1-28, sendRaw 29 (TTCS) for LaBr, or Gretina
110 mode 2only Decomp 1-28, sendRaw 29 (TTCS) for LaBr, coinc or Gretina ds 50 or LaBr ds 20
HERE WE SET THE S800 SYNCHRONIZATION CHECK BUTTON PROPERLY
130 mode 3 TTCS + LaBr, coinc or Gretina ds 50 or LaBr ds 20
6/9/12 data1a/MSUJune2012 162 mode 3 TTCS, or Gretina with ~ 1 MeV threshold, “Super Pulse” measurement, IOC of CRY#7 failed after 2 hours
6/10/12 data1a/MSUJune2012 165 mode 3 TTCS, or Gretina with ~ 1 MeV threshold, “Super Pulse” measurement, CRY#7 only
QUADS MOVED TO THE FINAL CONFIGURATION. Q2 and Q5 are not swapped any more
6/13/12 data1x/MSUJune2012 171 mode 3 Validate 0.2 us 60Co only Q1 Q2 Q3 with old positions
IOCs and decomps configured for the new position
6/14/12 data1x/MSUJune2012 184 mode 3 Validate 0.2 us 60Co with new positions
data1x/MSUJune2012 203 mode 3 Validate 0.2 us 60Co 37GB – BLR on – analysis bug
6/15/12 data1x/MSUJune2012 204 mode 3 Validate 0.2 us 60Co 37GB – BLR off
data1x/MSUJune2012 211 mode 3 Validate 0.2 us 60Co 37GB – BLR on (readout_limit 2000) – scrap
data1x/MSUJune2012 240 mode 3 Validate 0.2 us 60Co 37GB – BLR on (readout_limit 500)
6/17/12 data1x/MSUJune2012 252 mode 3 Validate 0.2 us 60Co 15min – readout_limit 100 (500)
data1x/MSUJune2012 253 mode 3 Validate 0.2 us 60Co 15min – readout_limit 200 (500)
data1x/MSUJune2012 254 mode 3 Validate 0.2 us 60Co 15min – readout_limit 300 (500)
data1x/MSUJune2012 255 mode 3 Validate 0.2 us 60Co 15min – readout_limit 500
data1x/MSUJune2012 256 mode 3 Validate 0.2 us 60Co 15min – readout_limit 700
data1x/MSUJune2012 257 mode 3 Validate 0.2 us 60Co 15min – readout_limit 1000
data1x/MSUJune2012 258 mode 3 Validate 0.2 us 60Co 15min – readout_limit 1500
data1x/MSUJune2012 261 mode 3 Validate 0.2 us 60Co 15min – readout_limit 2000
data1x/MSUJune2012 270 mode 3 TTCS 2 us 60Co 15min – readout_limit 500
data1x/MSUJune2012 271 mode 3 TTCS 2 us 60Co 15min – readout_limit 2000
swap found in Q7P2 between signal cable 3 and 4 – fixed
6/18/12 data1x/MSUJune2012 298 mode 3 Validate 60Co Q2 and Q5 – 20us
6/19/12 data1x/MSUJune2012 308 mode 3 Validate 0.2 us 60Co – Q2 in rotated position → good resolution but P3a3
data1x/MSUJune2012 315 mode 3 Validate 0.2 us 60Co – Q6P2 fixed
6/20/12 data1x/MSUJune2012 341 mode 3 Validate 0.2 us 60Co – test of North hemi - Q2P3a3 to be fixed
data1x/MSUJune2012 344 mode 3 Validate 0.2 us 60Co – calibration run 45min - check of north hemi
data1x/MSUJune2012 345 mode 3 Validate 0.2 us 60Co – calibration run - check of north hemi
data1x/MSUJune2012 346 mode 3 Validate 0.2 us background run - checking dynamic range
6/21/12 data1x/MSUJune2012 383 mode 3 Validate 0.2 us 60Co – calibration of North hemisphere
changed ID position for the detectors
6/21-22/12 data1x/MSUJune2012 401 mode 2 TTCS 2 us 60Co – test of decomposition for northern hemi
data1x/MSUJune2012 404 validate mode 0.2us 60Co – test of northern hemi again
data1x/MSUJune2012 405 validate mode 0.2us 60Co – calibration of the southern hemi
data1x/MSUJune2012 408 mode 2 - 2us 60Co – Southern hemi - test of calib 1
data1x/MSUJune2012 409 mode 2 - 2us 60Co – Southern hemi - test of calib 1
New directory in use: /global/data1x/gretina/MSUTestBeam_June2012
data1x/MSUTestBeam_June2012 6 mode 2 TTCS - 2us Background – Full Gretina

Trace: • list

QR Code
QR Code run:list (generated for current page)