procedures:calibrations:pulser_ramp
This is an old revision of the document!
Pulser Ramp Calibration
In a pulser ramp calibration, a tail pulser is used to pulse a system at many equally spaced pulse amplitudes. This can be used to test the linearity of the system and to find the zero offset. We have used it for both the Si ASICs and the CsI preamps.
Setup
Calibration
Analysis
procedures/calibrations/pulser_ramp.1277500546.txt.gz · Last modified: 2010/06/25 17:15 by dancoupland
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
